2008 Toyota Sienna
Mileage
104,819
Service Date
7/6/2023
Services Performed
- Change Motor Oil & Filter, Lube Chassis Up to 5 quarts & spin on filter Preform 19 Point Inspection Reset Maintenance Light & Tire Pressures Replace Lube Sticker Specialty filter & Additional Oil Charge May Apply
- CABIN AIR FILTER – CLEAN – [Driving in heavy traffic, on dirt roads or in urban, dusty or desert areas may shorten filter's life. Replacement may be necessary if you notice reduced air flow from the air conditioner and heater or if the windows fog easily when you use the "Fresh" mode.] BALL JOINT & DUST COVERS – INSPECT – [Check the suspension and steering linkage ball joins for looseness and damage. Check all dust covers for deterioration and damage. Replace any deteriorated or damaged parts.] BRAKE DRUMS & LININGS – INSPECT – [Check the brake linings (shoes) and drums for scoring, burning, fluid leakage, broken parts and excessive wear. Replace any deteriorated or damaged parts.] BRAKE HOSES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration and signs of leaking. Replace any deteriorated or damaged parts.] BRAKE LINE PIPES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration and signs of leaking. Replace any deteriorated or damaged parts.] BRAKE PADS – INSPECT – [Check pads for excessive wear. Replace any deteriorated or damaged parts.] CONDENSER – INSPECT – [Inspect for damage, debris, dirt, insects and signs of leakage.] DISC BRAKES – INSPECT – [Visually inspect discs. Replace any deteriorated or damaged parts.] DRIVE BELTS – INSPECT – [Inspect for cracks, excessive wear and oiliness. Check the belt tension and adjust if necessary. Replace the belts if they are damaged.] DRIVESHAFT/PROPELLER SHAFT DUST BOOTS – INSPECT – Drive Shaft Boots – [Check the drive shaft boots and clamps for cracks, deterioration and damage. Replace any deteriorated or damaged parts and, if necessary, repack the grease.] ENGINE COOLING SYSTEM HOSES & CLAMPS – INSPECT EXHAUST PIPES & MOUNTS – INSPECT – [Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration and damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten connections or replace parts as necessary.] RADIATOR – INSPECT – [Inspect for damage, debris, dirt, insects and signs of leakage.] STEERING GEAR/RACK – INSPECT – [Check for damage/leaks.] STEERING LINKAGE & BOOTS – INSPECT – [With the vehicle stopped, check for excessive freeplay in the steering wheel. Inspect the linkage for bending and damage and the dust boots for deterioration, cracks and damage. Replace any damaged parts.] TRANSFER CASE FLUID – INSPECT ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE ENGINE OIL REPLACEMENT REMINDER LIGHT – RESET – [Reset the oil replacement reminder ("MAINT REQD") light after replacing engine oil, if vehicle is equipped with this light.] DRIVESHAFT/PROPELLER SHAFT BOLTS – RETORQUE – Propeller Shaft Bolt TIRES – ROTATE – [Check tire tread depth and for uneven or excessive wear.]
- P/F marker lamp out, passenger tag lamp out. Air filter is dirty.
- Brake inspection Road Test Vehicle. Remove and re install Wheel, Inspect Entire Brake system, Fluid, and Brake Line condition. Hydraulic leaks. Pad lining remaining is: Front (45-50 %) Rear (50-55 %) Notes: R/R backing plate touching rotor slightly. Repositioned backing plate.
- RETURN WHEEL LOCK KEY TO PROPER AREA (If applicable)
- Replace bulbs
Alec H. gave our service a 5 star review on 7/6/2023
